A metal standing seam roofing product attached to sub-framing using a variety of concealed, interlocking clIMP that provide for minimum panel penetrations. This panel can be used on new construction as well as retrofit on existing structures. This panel design provides a high degree of weathertightness and has been tested by independent laboratories in accordance with ASTM E283 and E331 (for air infiltration, water penetration, and wind uplift).

24 (std.), 22 available by request
Recommended for roof slopes of ¼:12 or greater. When using the fixed clip we recommend for double slope buildings 200' wide or less and single slope buildings 100’ wide or less.(May vary upon extreme weather conditions.) Oil-canning is not a reason for rejection.
50' maximum is standard but longer lengths available by special request.
24" or 18" wide by 3" high
New and retrofit applications
Concealed fastening system. The clIMP are available as floating or fixed. Two different clip heights are available to allow for thermal blocks.
Galvalume®, Signature® 300 optional

- No panel penetration is required over the building envelope except at the end laps, and panel ends which are connected by a compression joint
- Panel side laps arrive at the job site containing a pre-applied sealant
- Optional product and weathertightness warranties
- Factory notched at both ends with pre-punched holes
- End laps have a 16 gauge backup plate with pre-punched holes
- High or low clIMP
- UL 90
- 80% less exposed fasteners than traditional side lap panels and all-fasteners are long life
- Panel available in Signature® 300 Series
- The side lap has been tested for air infiltration and water
penetration-under ASTM E283 and E331 methods

- Specially designed to seal out the elements
- Contributes to the system’s weathertight construction and ease of-erection
- Severe weathertightness and additional customer confidence
- Field installation can commence or finish from either end of building or on both sides simultaneously
- Solid connection at end laps and proper fastener spacing. The pre-punched holes improve erection and ensures proper panel placement
- Accommodates variety of insulation systems including 1"
thermal spacers at the purlins
- Increased weathertightness and improved appearance
- 20 year finish warranty
- Minimal air infiltration and water penetration and acceptability among specifiers
To view printable version, click here.
Note: Oil-canning is not considered grounds for rejection of any panel system. Oil-canning can occur in any panel with wide flat sections. Heavier gauge, embossing, striations, flatter sub-frame systems and support from a solid sub-deck can all help to minimize oil-canning.